Danby DPAC5009 - Manuel (Page 6)

REMOTE CONTROL FEATURES:
POWER CONTROL: The power control turns
the unit on and off.
MODE CONTROL: The mode control has 4
settings: Cool, Dehumidifiy, Fan, Auto. The settings
are adjustabed by the Mode Control button.
COOLING MODE: During the cooling mode,
the air is cooled and hot air is exhausted outside
through the exhaust tube. Adjust fan speed and temper-
ature to suit your desired comfort level.
Note: The air exchange hoses must vent outside the
room when using Cool mode.
DEHUMIDIFY MODE: Air is dehumidified as
it passes through the air conditioner, without being in
full cooling mode. If room temperatures is higher than
25°C (77°F), fan speed can be adjusted;
otherwise fan speed is fixed to “low”.
FAN MODE: Air is circulated throughout the
room with no cooling.
Note: Unit does not need to be vented in Fan mode.
AUTO MODE: In auto mode the unit will
switch mode and fan speed automatically based on the
ambient temperature.
LCD DISPLAY FEATURES:
FAN SPEED CONTROL: The fan speed
control has 4 settings: Auto (Cooling only), High,
Medium, and Low.
TEMP. SET CONTROLS :
The temperature can be set by means of the and
buttons on the remote control. The temperature can be
set between 16°C (61°F ) and 32°C (89°F). Pressing
the and buttons will cause the set temperature to
remain in the display panel for approximately 5
seconds. The display will then revert back to showing
the current room temperature.
Note: It is only possible to set the temperature when in
COOLING MODE. The temperature can not be set
when in AUTO, DEHUMIDIFYING or FAN mode.
FAHRENHEIT / CELSIUS SELECTOR:
Pressing this button will switch the display between
degrees Celsius and degrees Fahrenheit. Note: Initial
setting is °C
TIMER SETTING CONTROL: Press the
Timer button on the remote control to set the timer.
The ON or OFF logos (depending on timer modes “A”
or “B” below) will appear in the display panel, and the
clock symbol will flash for approx. 10 seconds; the
display panel will show a time of 8 hrs. While the
clock symbol is flashing, press the and buttons
on the remote control to select the time (in hours
between 00 and 24) for either of the timer modes “A”
or “B” (see below). The time selected will be shown on
the display panel and after approximately 10 seconds,
the clock symbol will remain illuminated together with
either the ON or OFF logo.
Timer Mode A) Auto Turn Off: With the machine on
and running, set the timer to select the number of hours
you would like the unit to run until it automatically
shuts off. The set time will be shown in the display
together with the clock symbol and the OFF logo.
Tiimer Mode B) Auto Turn On: Switch the machine
on using the ON / OFF button (either on the machine
itself or on the remote control) so that the machine is
running and the desired mode is selected. Press the
ON/OFF button again to put the machine into stand-by
mode. Set the timer to select the number of hours until
it is required for the machine to start up automatically.
The set time will be shown in the display together with
the clock symbol and the ON logo.
TIMER CANCEL CONTROL: If the time has
been set as in either “A” or “B” above and it is then
decided that the timer is not required, pressing the
CANCEL button will turn the timer off.
LCD DISPLAY SYMBOLS:
Auto mode
Cooling mode
Dehumidify mode
Fan only mode
High fan speed
Med. fan speed
Low fan speed
Display set temperature
Display timer setting of auto switch on/off
OPERATION
5
On/Off
Switch
LCD
Display