Danby DDR5009REE - Manuel (Page 13)

1) DO NOT use gasoline, benzene, paint thinner, or any other chemicals to clean t his unit, as these substances
will damage/deform the plastic components and luster finish.
2) Never attempt to clean the unit by pouring water directly over any of the surface areas, as this will cause
deterioration of electrical components and wiring insulation.
3) Use only a mild dish washing detergent, lukewarm water, and a soft cloth to wipe the exterior surface of
the unit and dry thoroughly.
CAUTION: Before attempting to clean and/or service this unit, always disconnect the
power supply cord from the electrical power supply / outlet.
When the dehumidifier is not being used for long periods of time, please follow these instructions:
1) Disconnect the power cord from the power supply.
2) Empty the water tank and wipe (clean) thoroughly.
3) Clean air filter thoroughly.
4) Re-package the unit in its original carton.
5) Store the unit upright in a dry location.
Some problems are of a minor nature and a service call may not be necessary. Use this troubleshooting guide
to identify possible problems you may be experiencing. If the unit continues to operate improperly, call your
local Danby Service depot, or 1-800-26-DANBY (1-800-263-2629) for assistance.
PROBLEM POSSIBLE CAUSE
Unit will not operate
• Check power cord connection
• Check electrical outlet for blown fuse
• Check if water tank is full (if so, empty)
• Check water tank is properly installed
Dehumidifying capacity (moisture removal)
low
• Air filter is dirty and/or blocked
• Ambient temp. too low (below 5°C/41°F)
• Poor airflow circulation/grill obstruction
• RH in surrounding environment very low
Relative Humidity (RH) setting not reached
after long period of operation
• Check all doors and windows are closed
• Area/room is too large for the capactiy of the
dehumidifier
CARE AND MAINTENANCE
CLEANING
THE UNIT
STORAGE
TROUBLESHOOTING
GUIDE
12