Velodyne vFree - Manuel (Page 7)

Charging headphones
Charging the vFree before using for the first time is recommended in order to maximize battery life. Low
battery is indicated by the LED status indicator flashing red approximately every 10 seconds.
To begin charging, connect the USB cable (micro USB end) to the port at the bottom of the left ear cup.
Connect the other end of the USB cable to any charge capable USB port or a USB-style charger. Your
vFree headphones will begin charging, as represented by the red LED status indicator. Once charging is
complete, the LED status indicator will illuminate green .
Pairing headphones
1. Make sure vFree headphones and pairing device are within 1 meter of each other when pairing
2. Enable Bluetooth function on pairing device
3. Press and hold the power button on vFree until the LED flashes blue and red repeatedly
4. Search for Bluetooth devices on pairing device
5. Select Velodyne vFree from the “Devices Found” list on the pairing device (if you do not see
Velodyne vFree, repeat from step 1)
6. After successful pairing, the LED indicator will flash blue every 5 seconds
Audio cable
When using the audio cable, the audio signal is applied directly to the headphone speakers and all
electronics are bypassed. No function of the headphones will work when using the audio cable other
than simply playing the audio signal.
Charge time About 1.5 hours
Talk time Up to 10 hours
Music playback time Up to 10 hours
Standby time Up to 100 hours
Fold your headphones
vFree headphones can fold for easier storage. To fold, remove any cables attached to the headphone
and push each ear cup inward towards the inside of the band.
vFree user’s guide
5
Reset functions
Software reset (paired device list reset) In off mode press and hold the power and volume
down (-) keys > 8 seconds. The LED indicator will
flash quickly alternating red and blue .
Hardware reset (use if the headset malfunctions
and is unresponsive)
While charging the headset press both the power
and volume up (+) keys.