Attention – Danby DAR1102W Manuel d'utilisation

Page 4

Advertising
background image

Remove exterior and interior packings, wipe the outside thoroughly

with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid

placing the cabinet in a narrow recess or near any heat source, direct

sunlight, or moisture. Let air circulate freely around the cabinet. Keep

the rear of the refrigerator 5 inches away from the wall.

Location

1. Select a place with a strong, level floor.
2. Allow 5 inches of space between the back of the refrigerator and

any adjacent wall.

3. Avoid direct sunlight and heat. Direct sunlight may affect the

acrylic coating. Heat sources nearby will cause higher electricity

consumption.

4. Avoid very moist places. Too much moisture in the air will cause

frost to form very quickly on the evaporator, and your refrigerator

will have to be defrosted more frequently.

To avoid vibration, the cabinet must be set level. This is accomplished by
adjusting the (2) front leveling legs located under the refrigerator cabinet. To
start the refrigerator, turn the temperature control (OFF-MAX) to the position
corresponding to the desired cooling.

OFF = No Cooling

1 = Minimum Cooling

The refrigerator temperature will vary depending on the quantity of the
food stored and on the frequency with which the door is opened.

ATTENTION

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an electrical short

circuit, grounding reduces the risk of electrical shock by providing

an escape wire for the electrical current. This appliance is equipped

with a cord having a grounding wire with a grounding plug. The plug

must be plugged into an outlet that is properly installed

and grounded.

WARNING -

Improper use of the grounding plug can result in a

risk of electric shock. Consult a qualified electrician or serviceman

if the grounding instructions are not completely understood, or if

doubt exists as to whether the appliance is properly grounded.

DO NOT USE AN EXTENSION CORD

Use an exclusive wall outlet. Do not connect your refrigerator to

extension cords or together with any other appliance in the same

wall outlet. Do not splice the cord.

IMPORTANT WARNING

An empty refrigerator is a very dangerous attraction to children.

Remove either the gasket, latches, lids or doors from unused

appliances, or take some other action that will guarantee it

harmless.

DON’T WAIT! DO IT NOW!

2

Safety Instructions

Operation

Installation

4 = Medium Cooling

MAX = Maximum Cooling

This refrigerator is inclusive of a cycle defrost system.
The refrigerator has a cold plate located in behind the back
wall of the refrigerator cabinet. Ice build-up on the back wall
during compressor operation is normal. When the compressor
has cycled off, accumulated ice will defrost automatically.
Defrost water will collect inside the drain trough pass through
the drain outlet located at the bottom of the cabinet and funnel
into a drain pan situated above the compressor. The water will
then evaporate from this tray from the heat of the compressor.

REMINDER: Keep the drain outlet opening clear of any food
particles or other impediments. This will ensure the water can
funnel to the drain pan without obstruction. Failure to keep
this outlet clean may result in water overflowing the trough,
causing water to accumulate at the bottom of the refrigerator,
eventually leaking onto your floor. Please wipe this trough and
drain outlet with a soft cloth as required.

Defrosting Instructions

Advertising