Dymo M10 - Manuel (Page 8)

4
Technical Specifications
NOT LEGAL FOR TRADE
For information about our other scale products, visit www.dymo.com.
Troubleshooting
If you need further assistance, contact Technical Support at (877) 724-8324. You can also
obtain support at www.dymo.com.
Model M10 M25
Capacity 10 pounds (4.5 kg) 25 pounds (11 kg)
Weight Increments 0.1 oz (2 g) 0.1 oz (2 g)
Accuracy
Under half the capacity
Over half the capacity ±0.2 oz
±0.4 oz ±0.2 oz
±0.4 oz
Units lb/oz (kg/g) kg/g (lb/oz)
Auto Shut Off After three minutes of inactivity
Operating Temperature 50° - 104° F (10° - 40° C)
Interface USB 2.0 Low Speed HID Scale Device
Power USB or 3 AAA alkaline batteries
Problem/Error Message Solution
No display Ensure the scale is plugged in, or replace the batteries.
LO is displayed Replace the batteries.
Negative number is displayed A tare value is displayed as a negative number when the items
are removed from the scale. Press
to reset the scale to zero.
00000 is displayed The item on the scale platform exceeds the maximum capacity
of the scale. Remove the item immediately to prevent damage
to the scale.
Display reads 0.0 with an item on the
platform This can happen because:
• The Tare/Zero button,
, was pressed while an item was on
the scale.
• Power to the scale was disconnected or turned off and then
on again with an item on the scale.
In both of these cases, remove the item from the platform and
press
to return the display to 0.0.
0.0
TARE
0.0
TARE
0.0
TARE