Paradigm Studio CC-690 v5 - Manuel (Page 5)

5
Fig. 5a For Center Channels with Outrigger Feet
Fig. 5c Attaching the Tilt Bracket when the Center Channel is positioned
below a Television/Display – included on models with cradles only
Fig. 5b For Center Channels with Cradles
STEP 1
Remove grille. To prevent scratching
the finish, carefully lay the speaker
on a blanket or soft drop cloth with
cradles positioned for easy access,
as shown. STEP 3
Push down firmly with both thumbs
where indicated (see inset) and bracket
will snap into place. Repeat steps 1
to 3 for second bracket.
IMPORTANT! Should you wish to remove the tilt bracket at a later
date, you must unscrew the entire cradle/tilt bracket assembly. DO NOT
attempt to pry off the bracket as this will damage the cradle.
Note: Bracket not for use with a Paradigm Stand
USE OF THIS TILT BRACKET IS RECOMMENDED, BUT OPTIONAL
STEP 2
Position bracket over cradle, as
shown. Align rear posts in bracket
with rear holes in cradle (see inset).
Press down firmly to engage posts.
Front posts will automatically align.