Doro 515C - Manuel (Page 7)

English
EN 4
Operation
Selecting headset or handset and speaker function
On delivery, the telephone is set for the handset and speaker function, but there is
also a simpler headset function.
The headset is instead connected to the handset and the
s
/
=
button is used to
connect/disconnect to the line (corresponding to lifting and replacing the handset).
Please note that the speaker function will not work when the headset function is
activated.
Activate the function by setting the switch
y
/
=
underneath the telephone to
=
.
Connection of headset
Disconnect the handset coil cord from the
y
/
=
socket firstly, then connect
the headset.
Important:
Even though the handset is disconnected it must be kept on the cradle at all times in the
headset mode of operation.
Please note!
DORO original headsets are tested and adapted for this telephone. Other types and makes of
headsets may be used, though the function and sound quality cannot be guaranteed.
In the worst case, these could damage the headset and telephone. This type of damage is not
covered by the telephone guarantee.
Headset function
When the Headset function is activated (see above), please use
=
to connect/
disconnect (corresponding to lifting and replacing the handset). The handset
and speaker function is not available when the headset function is activated.
1. Press
=
. The headset function will be activated and the LED indicator next
to the button will illuminate.
2. Dial the telephone number. Adjust the speaker volume using , if
required (underneath the handset).
3. Press
=
to terminate the call.