Freezer leveling and door closing, Door swing reversal and handle removal (optional), Door removal & replacement – Danby DUF177A1WDB Manuel d'utilisation
Page 6
6
Freezer Leveling and Door Closing
Your freezer has two front adjustable legs, one on each side. The back
of the freezer rests on two fixed rollers. The base grille covers the
adjustable brake feet and roller assemblies located at the bottom of the
freezer below the freezer door. Before making any adjustments, remove
the base grille and move the freezer to its final location.
Tools Needed:
¹⁄₄
" hex driver, Phillips head screwdriver
1. Remove the base grille screws. Grasp the grille firmly and pull it
toward you. Open the freezer door to access the brake feet.
NOTE: To allow the freezer to roll more easily, raise the brake feet
by turning them counterclockwise. The front rollers will be touching
the floor.
2. Move the freezer to its final location.
3. Lower the brake feet, by turning them clockwise, until the rollers
are off the floor and both brake feet are snug against the floor. This
keeps the freezer from rolling forward when you are opening the
freezer door.
IMPORTANT: If you need to make further adjustments involving the
brake feet, you must turn both brake feet the same amount to keep
the freezer level.
4. Make sure the door closes easily. If you are satisfied with the door
opening and closing, skip the next section. If, however, the door
does not close easily or the door pops open, adjust the tilt.
To Adjust the Cabinet Tilt:
NOTE: Having someone push against the top of the freezer takes some
weight off the brake feet. This makes it easier to turn them.
■
Open the freezer door. Use a
¹⁄₄
" hex driver to turn both brake feet
clockwise the same amount. This will raise the front of the freezer. It
may take several turns to allow the door to close more easily.
A. Cabinet Hinge Hole Plugs
A
Door Swing Reversal and Handle Removal (optional)
2
A. Grommet
B. Handle
C. Setscrews
A
B
C
1
3
Door Removal &
Replacement
Top Hinge
A. Top Hinge Cover
B.
5
/
16
"
Hex-Head Hinge Screws
C. Top Hinge
A
B
B
C
Bottom Hinge
A. Hinge Pin
B.
3
/
8
"
Hex-Head Hinge Screws
A
B
A. Hinge Pin
B.
3
/
8
"
Hex-Head Hinge Screws
A
B