Danby DPA120B3WDB - Manuel (Page 10)

9
Timer Setting
will set the auto-off time of the unit.
control will display TIMER ON, the last auto-on
time setting and the LCD display area will show
an ‘h.’ Now it’s ready to reset the auto-on time.
auto-on time. Each time you press the button,
the time increases by 30 minute increments, up
to 10 hours, then by 1 hour increments up to 24
hours.
3. After turning the TIMER ON, there will be a one-
half second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately 2 more seconds, the “h”
will disappear and the set temperature will
re-appear on the LCD display window.
To Set the Auto-On Time.
To Set the Auto-Off Time.
control will show TIMER OFF, the last auto-off
time setting, and the LCD display area will show
an “h.” Now it is ready to reset the auto-off time.
desired auto-off time. Each time you press the
button, the time increases by 30 minute
increments up to 10 hours, then by 1 hour
increments up to 24 hours.
3. After setting the TIMER OFF ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
1
2
Pressing the button will set the auto-on
time of the unit. Pressing the button
1. Press the button. The remote
2. Push the button again to set the desired
1. Press the button. The remote
2. Push the button again to set the