Danby DPA140HB1WDD - Manuel (Page 10)

time of the unit. Pressing the button
9
Timer Setting
will set the auto-off time of the unit.
control will display TIMER ON, the last auto-on
time setting and the LCD display area will show
an ‘h.’ Now it’s ready to reset the auto-on time.
auto-on time. Each time you press the button,
the time increases by 30 minute increments, up
to 10 hours, then by 1 hour increments up to 24
hours.
3. After turning the TIMER ON, there will be a one-
half second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately 2 more seconds, the “h”
will disappear and the set temperature will
re-appear on the LCD display window.
To Set the Auto-On Time.
To Set the Auto-Off Time.
control will show TIMER OFF, the last auto-off
time setting, and the LCD display area will show
an “h.” Now it is ready to reset the auto-off time.
desired auto-off time. Each time you press the
button, the time increases by 30 minute
increments up to 10 hours, then by 1 hour
increments up to 24 hours.
3. After setting the TIMER OFF ,there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "h" will disappear and the set temperature
will re-appear on the LCD display window.
1
2
Pressing the button will set the auto-on
1. Press the button. The remote
2. Push the button again to set the desired
1. Press the button. The remote
2. Push the button again to set the