Danby DPA120HB1WDB - Manuel (Page 13)

Installation Instructions
INSTALLATION IN A
SLIDING SASH
WINDOW 1. Measure the adhesive foam seal to fit the window stool. Cut the foam
seal (adhesive type) to the proper length and attach it to the window
frame. See Fig.13.
2. Adjust the length of the window slider kit according to the height of
window, shorten the adjustable window kit if the height of window is
less than 27inches. Open the window sash and place the window slider
kit on the window stool. See Fig.14.
3. Cut the foam seal (adhesive type) to the proper length and attach it to
the top of the window. Shown in Fig.15.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the open gap
between the top window sash and outer window sash. Shown in
Fig.16.
Foam seal A
(adhesive type)
Fig.13
Fig.14
Window
Panel
Fig.15
Foam
Seal
Fig.16
12
22.1”~ 38.6”