Angelcare AC420 - Manuel (Page 6)

6
Problem Possible Cause Solution
No sound is being transmitted. • Units are too far apart.
• Batteries are low or improperly installed.
• AC adaptors are not connected properly or electrical
outlet is out of order.
• One of the units is OFF.
• Bring parents unit closer to nursery unit.
• Check/replace batteries or recharge parents unit.
• Check connections or change to another electrical
outlet.
• Ensure both units are ON.
• Check the microphone sensitivity dial.
Power ON indicator (green light)
does not light up.
Display is not activated on the
parents unit. • Batteries are low or improperly installed.
• AC adapters are not connected properly or electrical
outlet is out of order.
•The nursery unit is at OFF position (“O”).
• Check/replace batteries or recharge parents unit
• Check connections or change to another electrical
outlet.
• Make sure nursery unit is ON (Left wing on “-”
position).
Static, distortion, interference
(interference from other monitors,
wireless phones, walkie-talkies,
etc…). • Parents unit is out of range.
• Parents unit is located near motorized devices, fluores-
cent lights, television, etc…
• Bring units closer together.
• Activate the out of range indicator on the nursery unit (left
wing up).
• Rotate parents unit or move it away from source of
interference.
Feedback (loud noises emitted from
parents unit). • Units are too close to each other.
• Volume is too high on the parents unit. • Move units farther apart (at least 3 meters/10 feet apart).
• Decrease volume on parents unit.
Very weak reception. • Units are too far apart (out of range indicator will flash and
beep on the parents unit).
• One or both units are placed near a large metal mass.
• One or both units are not in the upright position.
• Batteries are low.
• Bring units closer together.
• Change the position of one or both units.
• Place units on flat surface away from baby’s reach.
• Replace the batteries in the nursery unit or recharge the
parents unit.
TROUBLESHOOTING
VENTILATION: ALWAYS place both units on a flat surface in an
upright position so that air can flow freely around them.
AC POWER SOURCE: Use only the AC adaptors supplied with the
Angelcare
® Monitor.
CORD PROTECTION : Avoid damage to the adapter cords. Route
cords so that they are not likely to be walked on or pinched by
items placed on or against them.
CLEANING: Disconnect all units before cleaning. DO NOT
immerse in water. Use a dry cloth to keep monitor free from dust.
DO NOT spray with cleaning products or solvents. Wipe with a
very slightly damp cloth with an antiseptic or mild detergent.
OBJECT AND LIQUID ENTRY: Care should be taken so that
objects do not fall onto units and that liquids are not spilled into
either unit through openings.
NON-USE PERIODS: When not using the monitor for a short
period, make sure to turn the units OFF before disconnecting
them, otherwise the units will revert to the battery mode. When
not using monitor for long periods, remove the batteries from
both units and disconnect the AC adapters from electrical outlet.
Night light does not light. • Night light is not turned ON
• Night light LED is burned • Press on the top clear button on the nursery unit
• Contact your distributor (see page 14).