Use hardware - - group ”a, No hardware required – Poulan 964 77 50-00 Manuel d'utilisation
Page 7
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
1
REAR MOUNTING BRACKET
(See Figs. 1A, 1B&1C)
NOTE; If your tractor already has four (4) shoulder bolts
installed on the rear drawbar, simply hang the mounting
bracket, lanced tabs towards bottom, on the bolts. Discard
hardware group “A“ and disregard the remaining Step 1
instructions.
BOLTS
SHOULDER
BOLTS
LANCEDTABS
TOWARD BOTTOM
FIG. 1A
If your tractor does not have four (4) shoulder bolts installed
on the drawbar, follow the instructions below.
Use Hardware - - GROUP ”A”
Only one set of hardware in GROUP "A" will be used to
mount the rear mounting bracket. To determine which set
is correct for your tractor, check to see if there are (2) two
upper corner ribs on each side of drawbar. If your tractor
has the upper corner ribs, use the (4) four self tapping
shoulder bolts, if your tractor does not have the corner ribs,
use the set of (4) four bolts and locknuts.
SEtFTAPPiNG SHOULDER BOLTS (See Fig. 1B)
1. Using the four formed holes in the drawbar, install the
four shoulder bolts as shown and tighten securely.
2. Hang the mounting bracket, lanced tabs towards bottom,
on the bolts.
UPPER CORNER
BIBS
SELF
TAPPING
SHOULDER
BOLTS
UPPER CORNER
RIBS
LANCEDTABS
TOWARD BOTTOM
FIG. 1B
BOLTS AND LOCKNUTS (See Fig. 1C)
1
.
2.
Assemble the mounting bracket, lanced tabs towards
bottom, using the four smaller Inside holes on the
drawbar.
Install the four bolts and locknuts as shown and tighten
securely.
LOCKNUTS
LANCEDTABS
TOWARD BOTTOM
F!G. 1C
2
COVER SEAL (See Fig. 2)
No hardware required
1. Align mark on seat with mark at cover opening.
2. Work seal into opening so cover sits between flanges
of seal.
ALIGNMENT
MARKS
QC
COVER SEAL
FIG. 2
3
SUPPORT POST (See Fig. 3)
Use Hardware - - GROUP "B"
A
CAUTION: Container support is spring
loaded and locked to the cover. Handle
cover assembly carefully so as not to
unlatch the cover from the container
support.
1. Rotate cover assembly onto its side as shown.
2.
Assemble support post to container support with
the three (3) carriage bolts and locknuts. Tighten
securely.
CARRIAGE
BOLTS
SUPPORT
POST
LOCKNUTS
FIG.3