Craftsman 919.670280 - Manuel (Page 7)

7-ENG D20590
SPRAY GUN
ASSEMBLY
7. Place assembled gun and wand on pressure
washer holder.
Checklist
Before going any further please review the following:
• Be sure you have completed assembly instruc-
tions.
• Double check all fittings to be sure they are tight.
IMPORTANT: Before any attempt to start your
pressure washer be sure to check engine oil (See
Engine Oil on page 8.)
Know Your High Pressure Washer
Read this Owner’s Manual and Safety Rules
before operation of your High Pressure Washer
Compare this illustration with our pressure washer to
familiarize yourself with the location of various
controls and adjustments. Save this manual for
future reference.
PUMP- Develops high pressure.
ENGINE RUN/STOP SWITCH- Sets engine in starting
mode for recoil starter — Stops running engine.
RECOIL STARTER- Used for starting the engine
manually.
SPRAY GUN ASSEMBLY (Contains Gun and Wand)-
Controls the application of water onto cleaning surface
with trigger device.
OIL FILL- Port where engine oil is poured.
GAS TANK/CAP- Cap is removed and unleaded
gasoline is poured.
HIGH PRESSURE OUTLET- Connection for high
pressure hose.
CHOKE- Used to start a cold engine.
HIGH PRESSURE
HOSE
HANDLE
HIGH
PRESSURE
OUTLET
PUMP
WATER INLET
CONNECTION
OIL FILL
GAS
TANK/
CAP
RECOIL
STARTER
ENGINE
STOP/
START
CHOKE
OPERATION
8. Place pull cord into the wire bracket holder.
• Pull the cord under the wire bracket to the
right of the wire loop.
• Lift the pull cord handle up and slide the cord
to the left, sliding the cord into the wire loop.
• Next slide handle behind the wire bracket to
the left of the wire loop.
• Engine recoil will pull the cord into its final
position.
Gun/Wand
Holder
Cord
Wire Bracket