Levana LV-TW100 - Manuel (Page 7)

7
BABY UNIT OPERATION
This system can be powered using batteries (not included) or by the AC adapter.
Battery Powered
1. Remove the battery compartment cover on the back of the baby unit using a small cross
head screwdriver.
2. Slide cover down and off using your thumb.
3. Install 3 AAA batteries (not included).
4. Replace battery compartment cover.
Adapter Powered
1. Plug the small end of the AC adapter into the 6V DC jack on the right hand side of the baby unit.
2. Plug the other end of the AC adapter into any available wall outlet.
Turning On
1. Press the button on the top of the baby unit.
2. A green LED on the front of the baby unit will indicate there is power.
3. To Turn OFF the baby unit, press the button on the top of the unit again and the green LED on the front
will go out.
Channel Selection
This system has two channels to operate on in case there is another product in the household using the
same frequency.
1.
To change the channel the system is using, slide the channel selection switch on the left hand side of
the baby unit to either CH1 or CH2.
2. Both the parent and baby units must be on the same channel to operate and transmit properly.
Note: 3 AAA batteries are required for the parent and baby units (not included). When replacing
batteries, do not mix old batteries with new ones, do not mix alkaline, carbon, or other types of batteries
and please remove batteries from both units if they will not be used for a long period of time.
Strangulation Hazard: Children can become entangled in cords. Power cords should be kept more
than 3 feet away from the crib and baby’s reach at all times. Baby monitors with power cords should
never be hung on or near the crib. Check your child’s safety at regular intervals.