Levana LV-TW501 - Manuel (Page 10)

10
SETTING UP YOUR SYSTEM
Placing the Baby Monitor
This monitor can be placed on a tabletop, you can also carry it on your belt or hang
it from a screw on the wall.
1. You can set up the monitor on a tabletop by turning the belt clip down and using it as a support
stand.
2. You can carry the monitor on your belt by turning up the clip on the back of the monitor and
sliding the clip over your belt.
3. You can also hang the monitor from a screw on the wall using the screw mounting hole in the
clip.
Battery Operation
The camera unit can be powered using 4 AAA batteries instead of the included AC adapter.
1. Remove the battery compartment cover on the bottom of the camera base, using a small
phillips (cross) head screwdriver.
2. Place 4 AAA batteries (not included) in the compartment, paying attention to the labelled
polarity markings.
3. Replace the battery compartment cover using the small screwdriver.
Note: The power LED will flash when the battery charge is low.
Attaching Power to the Camera
1. Connect the AC adapter to the transmitter as shown in the diagram.
2. Connect the small end into the DC Jack on the back of the camera, connect the other end of the
adapter into an available wall outlet.