Craftsman C583-930360 - Manuel (Page 6)

6
4. Insert nails into nail channel
through rear of nail chamber
(see Figure 4). Make sure nail
points are towards bottom of
tool.
Note: We recommend that you
only use CRAFTSMAN
® brad
nails in this tool. Wrong brad
nails can cause jamming.
5. Replace nail pusher into nail
chamber. Do this by inserting
flat metal end of nail pusher into
nail channel (see Figure 5).
Fully push nail pusher into nail
chamber. Push hook end of nail
pusher up and latch it to nail
chamber.
Brad Nails
Keep trigger lock in the OFF position and finger off trigger until
ready to drive nail.
WARNING !
WARNING ICON G 001
Keep all body parts away from nail exit opening on tool.
WARNING !
WARNING ICON G 001
1. Make sure trigger lock is in the OFF
position.
2. Plug tool into a 115 Volt/60 Hertz outlet.
3. Grip tool firmly and hold against work
surface. Use enough pressure to depress
safety lock. The safety lock is located on
nail exit of tool (see Figure 6).
IMPORTANT: The safety lock must be
depressed for this tool to operate. This
tool will not fire unless this is done.
Operating Tool
Safety Lock
Figure 6
Nail Channel
Figure 4
Nail Channel
Figure 5