Kenwood KAC-322 - Manuel (Page 5)

CONNECTIONS
INSTALLATION
1. Before installation and wiring,
remove the 0 terminal of the
battery to prevent short-circuiting.
2. Connect the input and output
cords of the system.
3. Connect the ground to the chassis
of the car.
Connect the power supply lead
(yellow).
5. Install the set and after confirming
the installation and wirings are
correct, connect the 0 terminal of
the battery.
Power-control tead jBlue/White]
4
If a fuse is blown, first check that
the associated wires are not short-
circuited then replace the fuse with
a new one having the same
capacity.
-CAUTJON-
As the unit uses BTL output, always connect
the without white stripe, gray stripe speaker
wires to the © terminals of the speaker
systems. Never let the 0 speaker wires
touch and never connect them to the
chassis (ground). Do not let the speaker
terminals come into contact with the chassis
(ground).
Insulate any unused output wire with vinyl
tape to prevent a short circuit.