Kenwood KAC-715 Manuel d'utilisation
Page 5
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

[ Connection with center unit
I Connection with genuine-accessory car stereo
RCA cable ground lead
^
terminal
^
When using an RCA cable with
a ground lead attached^ connect
the ground lead to this terminal.
Do not use this terminal for
power source grounding. This
unit will not operate if the
power source ground wire is
connected to this terminal.
I
A
CAUTION
I
Do not connect cables and leads to
both RCA cable input Jacks and the
speaker input terminals
simultaneously, for this may cause
malfunction or damage.
Front speakers
CEWTER UNIT
{Cassette receiver.
Graphic equalizer etc.)
Power
control
lead
Pre-out
Rear speakers
Left output {White}
Right output (Red)
Power control lead
(Commerciallv available parts!
Right input
' Power control lead terminal -
Connect the center unit's
power control lead to this
terminal.
Power control
lead terminal
Lead terminal
(Commercially
available parts)
Power control lead
(Commercially
available parts)
Speakers lead
(Commerciatfy available parts]
7777Ш
Battery
Speakers lead
{Commercjally available parts)
^Speaker lead terminak
Connect the speaker
leads to this terminal.
Lead terminal
(Commercially
available parts)
Power control lead
(Commercially available parts)
Speakers lead
terminal *
-,
,
.
Speakers lead
Polirlty of ftptflkar
\ 1 -
-
-
-
-
-
-
-
-
-
--
-
-
-
-
-
Г»
input terminals
Power control
L@ 1
10
1
Re|R®
terminal
A CAUTION
The genuine-accessory car stereo shall have a maximum power output of no
more than 25 W.
Do not connect the speaker output leads from a power amplifier (Optional) to
the speaker input terminals of this unit, for this may cause malfunction or
damage.
Do not connect cables and leads to both RCA cable input jacks and the speaker
input terminals simultaneously, for this may cause malfunction or damage.
Connect the power control lead to a power supply which can be turned ON/OFF
by the ignition key switch (ACC line),
With this connection, shock noise may be generated when the power of the
genuine-accessory car stereo is switched ON/OFF.