H change cooktop burner orifices, El change cooktop burner orifices (cont.), Installation instructions – GE PGP966DETBB Manuel d'utilisation
Page 14: Making the lp conversion (cont.)
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
Installation Instructions
MAKING THE LP CONVERSION (CONT.)
H CHANGE COOKTOP BURNER
ORIFICES
H Remove the top grates,
burner caps, and burner
heads.
E Remove the spark
igniters from the burner
base (if required to
access the orifices).
Using a No. 15 "Torx"
head driver bit, remove
the screws holding the
burner base in position.
E Using a 7mm nut driver,
remove the top burner
orifices. These may be
accessed through the
hole in the cooktop.
Remove This
y Assembly
Orifice Spud Located
Through This Opening
Burner cap
Burner
head i
Spark igniter
Burner
base
18,000 BTU Burner
(on some models)
Burner
Spark igniter
[El CHANGE COOKTOP BURNER
ORIFICES (CONT.)
3
Retainer
Ring
On most burners,
the orifices have a spring-
loaded retaining ring around
the hex head to hold the
orifice in the nut driver during
installation and removal. A
slight amount of force is required to push the nut
driver down over the ring.
NOTE: For orifices that do not have a spring-
loaded retaining ring, use pliers to hold the orifice
in position during initial thread (-^------------------^3
engagement or final removal to
avoid dropping the orifice in the
cooktop. Then use the nut driver
to tighten or loosen.
14