Setting the water level adjustment – Whirlpool BHDH2500FS0 Manuel d'utilisation

Page 7

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

De-Icer control
NOTE: Do not operate dehumidifier at tempera­

tures below IS.S’C (65°F). The coils may
become iced over and unit will not operate
properly.

Your dehumidifier is equipped with a feature to
help you get the most comfort from your new
appliance by permitting it to operate down to

18.3°C (es^F). If your dehumidifier runs when

room temperature and humidity conditions are
low, frost can form on its evaporator coil. This
interferes with proper operation.

The De-icer Control senses frost buildup on

the evaporator coil arid automatically shuts off
the compressor. The fan continues to run,
drawing air across the coii, and meiting the frost.
When the coil is defrosted, the compressor
automatically restarts, and dehumidifying

resumes.

Setting the water level
adjustment

The Water Level Adjustment can be set in two
positions to turn off the unit automatically when
the pan is fuil. This prevents the danger of
overfiow.

Pan must be in proper position for Water Level

Control Switch to work.
• NORMAL FILL - set Water Level Adjustment

to the indentation on the left side. The water
pan and water will weigh approximately 7.2 kg

(16 lbs.) and water pan will be Vi full.

• MAXIMUM FILL - set Water Level Adjustment

to the raised area on the right side. The water
pan and water will weigh approximately 10.8 kg

(24 lbs.) and water pan will be V« full.

The Water Level Control Switch will automatically
turn off the dehumidifier at the fill level you
selected when pan is properly placed. Loosen
the screw to move the Water Level Adjustment.

Retighten screw when adjusted to desired

setting.

Advertising