Whirlpool 810 - Manuel (Page 12)

top of panel under
control console
insert
between
sides
panel tits between,
not inside, door frame
O ■ Insert top of wood door
panel between sides of door frame
about 3" (7.5 cm) below console.
Rotate wood door panel down
against dishwasher door. Siide top
edge of wood door panel under
bottom edge of console. Press
lower portion of wood door panel
in place between sides of door
frame, allowing wood door panel
to rest on channel at bottom
of door.
Snap retainer
into channel.
wood
panel
Push in
along length
ot retainer.
I Snap one end of retainer into
channel as shown. Push inward
while sliding thumb along full
length of retainer.
f ■ Check door for proper
operation. Door should close easily
without slamming and open with
its own weight. If necessary, close
door and adjust both door springs
by moving spring ends to different
holes in base.
8
. ► ■ Push
up with
thumbs
on each
end of
access
panel top
trim to
\-
unsnap trim. Remove top trim
and set it aside.
Carefully slide
colour access
panel and
spacer upwards
and remove.
Save colour access panel and
spacer for future use.
10
. I Insert wood access panel
into access panel frame. Slide
panel down into groove along
bottom of access panel frame. It
may be necessary to remove the
two screws securing top of access
panel to dishwasher frame and tilt
access panel forward fo install
some wood panels.
11» Line
up edges of
top trim with
sides of access
panel frame.
Tilt back of trim
down and slide into place. Snap
front of trim down to cover top
edge of wood access panel.
If the
dishwasher is
not operating
properly...
Check these points:
• Is the door closed tightly and
latched securely?
• Has the cycle been set correctly
to start the dishwasher?
• Is the water supply turned on?
• Has the electrical power been
connected?
• Has the circuit breaker been
tripped or the house fuse blown?
• Has electrical power been
interrupted?
Note; If the motor is stopped
because of overload, it will
automatically reset itself within a
few minutes. If after checking these
points the dishwasher still does not
run or complete a cycle, call for
service.
If you need
assistance...
Call your dealer or authorized
repair service.
When you call, you will need the
dishwasher model number and
serial number. Both numbers can
be found on the model/serial
rating plate behind the dishwasher
door on the front frame,
Part No. 3369689
©1996 Benton Harbor, Michigan 49022 Printed in U.S.A.