Panasonic CYVM1500EX - Manuel (Page 30)

Installation Guide
(continued)
I Remove the display unit from the height adjuster fitting. Peel off the cover paper from the metal fit­
ting body and attach the metal fitting body to the attachment location. After attaching, secure with
the fastening screws included. {Be sure to carefully clean away any dirt from the attachment loca­
tion and dry the surface before attaching. After attaching, push strongly onto the spot to ensure
that the metal fitting body is securely attached.)
Pee! off the cover paper
from the back side
Secure with the monitor stand
fastening screws (in 5 spots)
After attaching the metal fitting body
For the next 24 hours, do not pull at the metal fitting body or attach the display unit (since this will
weaken the adhesive strength and could cause the metal fitting body to come off).
0 After waiting 24 hours, place the display unit on the height adjuster fitting.
Removing the metal fitting body
• Remove the screws and slowly detach the metal fitting body starting from the corners of the at­
tached surface. (When the temperature is low, turn on the car heater or use a dryer to warm up the
attached surface.)
• When adhesive tape remains on the attached surface, use your finger or other instrument to re­
move the remaining tape.
30
CY-VM1500EX