Cooper 9448ES - Manuel (Page 2)

2 496572
UK
9448+ and 9448ES Hard Wired Control Panel User Guide.
© Scantronic Ltd. 2001
Every effort has been made to ensure that the contents of this book are correct, errors and omissions excepted.
However, neither the authors nor Scantronic accept any liability for loss or damage caused or alleged to be
caused directly or indirectly by this book. The contents of this book are subject to change without notice.
Printed in China.
Operator Controls and Displays
On both control panel and remote keypad the LEDs
display the following functions:
a Glows steadily when mains power is present.
E Shows the state of the entry/exit zone.
1 - 6 Shows the state of detector zones 1 to 6.
T Glows steadily if the tamper loop is broken.
D Glows when the system is unset, flashes when part
set.
The keypad on the control panel and 9427 provide
the following keys:
O Used to set the panel with individual zones tempo-
rarily omitted.
R Used to enter programming and setting/unsetting
commands.
P Pressing the two PA keys (1 and 3) at the same
time starts a PA alarm (if this function is enabled in
programming).
p Used to set the system with a preprogrammed
number of detectors omitted.
B Used to start a test of the sounders and strobe.
W Used to start a test of the detectors.
c Used to change the user access code.
C Used to enable or disable the Chime facility.
l Used to read the 10-event log. When reading the
log, pressing << (1) displays earlier events, and >>
(3) displays later events.
English