Ryobi RY09440 - Manuel

WARNING: This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.
Pour fresh gasoline into the fuel tank.
Slowly press the PRIMER BULB 10x or until fuel appears.
Pull starter handle until engine attempts
to start (4X max.)
RYOBI ART WORK
Art Part No. : 987000-840 Rev. 03
Where Used : 987000-840
Refer to Drawings for Dimensions.
987000-840
8-18-10 (REV:03)
1 GALLON
GAS
ENGINE STARTING PROCEDURE Material: 60lb. Stock Paper.
Color: Orange Yellow.
FRONT
For any questions about operating or maintaining your product, call the Ryobi ®
Help Line !
Your product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
CALL
1-800-860-4050
www.ry
obitool
s.com
TO START:
1
2
3
4
5
PRESS and HOLD stop switch until
engine stops.
TO STOP:
SET throttle/cruise control lever to IDLE.
SET choke lever to FULL choke.
6
SET choke lever to HALF choke.
Pull starter handle until engine starts (6X max.)
NOTE: If the unit has not started, return to step 3.
7
8
Allow the engine to warm for 10 seconds,
SET choke lever to RUN.
TO RESTART A WARM ENGINE:
If the engine/unit is already hot:
Set the throttle/cruise lever to IDLE. Do not squeeze the throttle to start a hot engine.
SET choke lever to RUN.
Pull starter handle until engine starts (6X max.)
9
LUBRICANT
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
10
PRIME
SET TO
x10
LOCK
THROTTLE LEVER
SET TO
2
WAIT 15 SEC
SET TO
(4X MAX)
1
3
4
5
6
7
PULL UNTIL ENGINE S TARTS
PULL UNTIL ENGINE ATTEMPTS TO START
(6X MAX)
3
2
6
8
1
10
5
4 7
9