Petsafe Comfort Fit Remote Trainer - Manuel (Page 6)

6 www.petsafe.net
Prepare the Receiver Collar
To Insert and Remove
the Battery
Note: Do not install the battery while
the Receiver Collar is on your pet.
This Receiver Collar uses a replaceable
PetSafe
® battery (RFA-67). This unique
battery is designed to make battery
replacement easier and increase water
protection.
To insert the battery, align the symbols
on the battery (arrow) and Receiver
Collar (triangle). Using the edge of
the Test Light Tool as shown, turn the
battery clockwise until the arrow lines
up with the lock symbol on the housing
(2A, 2B).
To remove the battery, turn the battery
counter-clockwise using the edge of the
Test Light Tool as shown (2C, 2D).
2A 2B
2D 2C
DO NOT attempt to cut into or pry open the battery. Be sure to discard the used
battery properly.
A replacement PetSafe ® battery (RFA-67) can be found at many retailers. Contact the
Customer Care Centre or visit our website at www.petsafe.net for a list of common
retailers.
To Turn the Receiver Collar On:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
2. Release the On/Off Button.
Once the Receiver Collar has been turned on, press the Side Button of the Remote
Transmitter. The Receiver Collar should beep for as long as the Side Button is pressed.
If it does not, see the “Reset the Receiver Collar” section.
The Receiver Indicator Light will fl ash once every 4 to 5 seconds if the battery is low.
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 2 times.
2. Release the On/Off Button.
Note: To extend the life of the battery, turn the Receiver Collar off when it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery
life (before replacing batteries) will be two weeks.
Step
2