Chamberlain 3800C - Manuel (Page 26)

26
*3-Button Remote
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security
✚ ®
3-Button remote or
mini-remote can be
programmed to operate
other Security
✚ ®
garage door openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6-9 seconds).
All previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security ✚ ® remote controls.
1. Press and hold the button on the hand-
held remote * that you wish to operate
your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Motion Detecting Control Console.
3. Continue holding both buttons while
you press the push bar on the Motion
Detecting Control Console (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
1. Press and release the purple “learn”
button on the motor unit. The learn
indicator light will glow steadily for 30
seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote * that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE MOTION DETECTING CONTROL CONSOLE
LOCK LIGHT
PROGRAMMING
NOTICE: If this Security
✚
® garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
LOCK
LIGHT
LOCK
LIGHT
LOCK
LIGHT
LOCK LIGHT