Dell OptiPlex 9010 All In One (Mid 2012) - Manuel (Page 67)

PRÉCAUTION : The password features provide a basic level of security for the data on your computer.
PRÉCAUTION : Anyone can access the data stored on your computer if it is not locked and left unattended.
REMARQUE : Your computer is shipped with the system and setup password feature disabled.
Assigning a System Password and Setup Password
You can assign a new System Password and/or Setup Password or change an existing System Password and/or Setup
Password only when Password Status is Unlocked. If the Password Status is Locked, you cannot change the System
Password.
REMARQUE : If the password jumper is disabled, the existing System Password and Setup Password is deleted and
you need not provide the system password to log on to the computer.
To enter a system setup, press <F2> immediately after a power-on or re-boot.
1. In the System BIOS or System Setup screen, select System Security and press <Enter>.
The System Security screen appears.
2. In the System Security screen, verify that Password Status is Unlocked.
3. Select System Password , enter your system password, and press <Enter> or <Tab>.
Use the following guidelines to assign the system password:
– A password can have up to 32 characters.
– The password can contain the numbers 0 through 9.
– Only lower case letters are valid, upper case letters are not allowed.
– Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
Re-enter the system password when prompted.
4. Type the system password that you entered earlier and click OK.
5. Select Setup Password, type your system password and press <Enter> or <Tab>.
A message prompts you to re-type the setup password.
6. Type the setup password that you entered earlier and click OK.
7. Press <Esc> and a message prompts you to save the changes.
8. Press <Y> to save the changes.
The computer reboots.
Suppression ou modification d'un mot de passe système et/ou de configuration
Vérifiez que l'état de mot de passe est Déverrouillé (dans la configuration du système) avant de supprimer ou de
changer un mot de passe système et/ou de configuration. Vous ne pouvez pas supprimer ou changer un mot de passe
système et/ou de configuration si l'état de mot de passe est Déverrouillé.
Pour entrer dans la configuration du système, appuyez sur <F2> immédiatement après la mise sous tension ou un
redémarrage.
1. Dans l'écran System BIOS (BIOS du système) ou System Setup (Configuration du système), sélectionnez System
Security (Sécurité du système) et appuyez sur <Entrée>.
L'écran System Security s'affiche.
2. Dans l'écran System Security, vérifiez que l'état de mot de passe est Déverrouillé.
67