Baumer DFOx - Manuel (Page 4)

Identification
Input 100%
Loop current at 100%
(e.g. 20 mA)
Input 0%
Loop current at 0%
(e.g. 4 mA)
Input
Damping 0 = off / 1…30 sec.
Liniarization
correction
Enable / Disable
Display 100%
Displayed value
at 100% input
Display 0%
Displayed value
at 0% input
Decimals Digits after point
Display output Units Pressure units
Temperature units
Electric units
Configuration
Other units
Abs./Rel.
Select Absolute/Relative
or none
High error High error limit
MENU
High error indication
High error backlight
Error/warning setup
High warning Same as for high error
Display setup
Low warning Same as for high error
(see page 3)
Low error Same as for high error
Diagnostics
Relay 1 mode AO / AC / NO / NC
Relay 1 set point Point at which relay sets
Relay 1 reset point Point at which relay resets
Relay setup
Relay 2 mode AO / AC / NO / NC
Relay 2 set point Point at which relay sets
Relay 2 reset point Point at which relay resets
This menu section is only accessible when the relays are activated
TAG No. / Serial No. / Date / Prod.date
Page 4 La conception et les spécifications peuvent faire l'objet de modifications sans préavis.
Manuel d'installation www.baumer.com/process
5850-006 _FR/2012-04-02 Cette fiche technique ne peut être par
tiellement reproduite
.
Programmation
Cette section du menu n’est accessible que si les relais sont activés.
Voir page 3