Craftsman 919.72755 - Manuel (Page 7)

7 - ENG D23122
ASSEMBLY
Contents of Carton
1 - Air Compressor
4 - Rubber Feet
1 - 3/8” x 25’ Hose
1 - Brad Nailer
2 - 1/4” Quick Connect Body
2 - 1/4’ Quick Connect Plug
1 - Roll of Teflon Tape
Tools Required for Assembly
1 - 3/8” socket or nut driver
Assemble Rubber Feet
1. Carefully place unit on side opposite of controls.
Leg
Rubber Foot
Screw
GLOSSARY
Become familiar with these terms before operating the
unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per minute; a unit of
measure of air delivery.
PSIG: Pounds per square inch gauge; a unit of meas-
ure of pressure.
Code Certification: Products that bear one or more
of the following marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified independent safety
laboratories and meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your accesso-
ry. When the tank pressure drops to a certain low
level the motor will restart automatically. The low
pressure at which the motor automatically restarts is
called “cut-in” pressure.
Cut-Out Pressure: When an air compressor is
turned on and begins to run, air pressure in the air
tank begins to build. It builds to a certain high pres-
sure before the motor automatically shuts off - pro-
tecting your air tank from pressure higher than its
capacity. The high pressure at which the motor shuts
off is called “cut-out” pressure.
Branch Circuit: Circuit carrying electricity from elec-
trical panel to outlet.
ACCESSORIES
Accessories
• In Line Filter
• Tire Air Chuck
• Quick Connector Sets
(various sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose:
1/4", 5/16" OR 3/8" I.D.
in various lengths
Specialty Tools
• Air Brush
• Inflating/Blow Gun
• Grease Gun
• Caulk Gun
• Engine Cleaner
Carpentry Tools
• Finishing Nailer / Stapler
• Construction Nailer / Stapler
Socket Driving
• 3/8" Impact/Butterfly Wrench
• 3/8" Ratchet
• 1/4" Ratchet
Material Shaping
• 2.625" Hammer
• 1.625" Hammer
• Reciprocating Saw
• Nibbler
Spray Painting
• Multi-Purpose Spray Gun
• Automotive Spray Gun
This unit is capable of powering the following Accessories. The accessories are available through the current
Power and Hand Tool Catalog or full-line Sears stores.
2. Using a 3/8 inch socket or nut driver remove the
screws attaching the unit to the shipping pallet.
NOTE: These screws will be used to install the rub-
ber feet.
3. Attach the four rubber feet to the unit’s legs using
the four screws removed in step 2.
NOTE: Flat side of rubber feet goes against unit legs.