CCI Thermal Technologies AV - Advanced Vertical Unit Heater - Manuel (Page 6)

6
MOTOR WIRING DIAGRAMS
CAUTION
Installation must be done by qualified personnel, and comply with local electrical codes.
For internal wiring of control devices and starters,
consult device manufacturer. The thermostat must have an electrical rating
equal to or exceeding the rating of the control device. For wiring of the fan motor, refer to diagram on
the motor. These wires must be connected in series with the motor control circuit.
FIGURE 7
- 6 -
MOTOR WIRING DIAGRAMS
CAUTION
Installation must be done by qualified personnel, and comply with local electrical codes.
For internal wiring of control devices and starters,
consult device manufacturer. The thermostat must have an electrical rating
equal to or exceeding the rating of the control device. For wiring of the fan motor, refer to diagram on
the motor. These wires must be connected in series with the motor control circuit.
MOTOR WIRING DIAGRAMS
CAUTION
Installation must be done by qualified personnel, and comply with local electrical codes.
For internal wiring of control devices and starters,
consult device manufacturer. The thermostat must have an electrical rating
equal to or exceeding the rating of the control device. For wiring of the fan motor, refer to diagram on
the motor. These wires must be connected in series with the motor control circuit.
FIGURE 7
- 6 -
WIRING DIAGRAM FOR BUILT-IN DISCONNECT SWITCH HEATERS
SINGLE PHASE
Tandem Motor Unit
SINGLE PHASE
Single Motor Unit
THREE PHASE
Tandem Motor Unit
THREE PHASE