Braun NC1000 - Manuel (Page 16)

17
If you cannot find a solution to your problem, please contact Braun customer service.
Machine does not produce
coffee, only hot water is coming
out. The water signal is lit. Coffee/water selector (Q) not in
correct position. Turn the coffee/water selector
(Q) to «coffee» and make sure
that the coffee container (A) is
firmly inserted in the machine.
The water signal (F) is blinking. Water tank (C) is empty or it is
not firmly inserted in the
machine. Ensure there is enough water
in the tank (C). The signal
disappears when any of the cup
buttons is pressed.
I need to stop the preparation
process. How do I empty the
brewing unit (U)? I realise that my cup is too small
for my desired drink. Press the «stop» button (D). The
cup lights are blinking one after
the other and the machine stops
immediately. Press the cup
button (K) until the brewing unit
(U) is empty.
The water filter exchange signal
(E) lights up. The signal is a reminder to
change water filter. Change the water filter (see
«Water Filter») then press the
«stop» button (D) for 5 seconds
to reset the signal.
All cup signals are lit. Machine is calcified. Descale the machine (see
«Descaling»).
Coffee has spilt over the
machine. I have spilt dry coffee over the
machine. Coffee residue can be removed
using a vacuum cleaner or
another dry cleaning method.
All the lights are blinking. Error detection. Contact an authorised Braun
service centre.
Problem Situation Solution
Transport
The machine must be completely empty before
carrying it. Never attempt to empty the machine
immediately after preparation. Allow unit to cool
down for 20 minutes first.
• Remove the water tank (C), the drip tray (N) and
the coffee container (A).
• Carry the unit to a sink.
• Switch the coffee/water selector (Q) to the
«water» position.
• Open the water filter compartment (B) and
remove the water filter (L).
• Tip the machine onto its rear right-hand corner
to allow the water to pour into the sink through
the water filter compartment (B).
• Move the machine back into its vertical position.
Water will run out of the machine through the
pure water pipe (O).
• Repeat these steps until no more water runs
out.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
Please do not dispose of the product in the
household waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection points
provided in your country.
3150350_Nescup_S6-24 Seite 17 Donnerstag, 6. Oktober 2005 3:05 15