Metrohm 768 KF Oven - Manuel (Page 31)

3.2 Remote control commands3.2 Remote control commands
768 KF Oven
28
.ChangedOnly: Sends only those paths and their values which have once been edited. All
path names are sent in absolute terms, i.e. from the root.
3.2.2.34
Setup.Trace ON, OFF
The KF Oven reports when a value has been confirmed with <ENTER> at the KF Oven.
Space (ASCII 32) and & are sent as introducers.
Example: &Mode.Temp"100"
3.2.2.35
Setup.Lock.Keyboard ON, OFF
Setup.Lock.Config ON, OFF
Setup.Lock.Parameter ON, OFF
Setup.Lock.Heater ON, OFF
Setup.Lock.Pump ON, OFF
Setup.Lock.Valve ON, OFF
Setup.Lock.Boat ON, OFF
Setup.Lock.Display ON, OFF
ON means locking of the corresponding function:
.Keyboard:
Locking all keys at the KF Oven.
.Config: Locking the <CONFIG> key.
.Parameter: Locking the <PARAM> key.
.Heater:
Locking the <HEATER> key.
.Pump: Locking the <PUMP> key.
.Valve: Locking the <VALVE> key.
.Boat: Locking the <BOAT IN> and <BOAT OUT> keys.
.Display: Locking the display, it is not operated by the device program of the KF Oven
and can be written to by the computer.
3.2.2.36
Setup.TController.InitHeatFactor 0...100...200
Setup.TController.AddHeatFactor 0...100...200
Factors for the temperature controller, see page 12.
3.2.2.37
Setup.SendMeas.SendStatus ON, OFF
Setup.SendMeas.Interval 1...4...16200
Setup.SendMeas.Meas.CyclNoON, OFF
Setup.SendMeas.Meas.SampleTemp ON, OFF
Setup.SendMeas.Meas.OvenTemp ON, OFF
Setup.SendMeas.Meas.GasFlowON, OFF
.SendStatus: ON means automatic transmission of measured values (see below) at the
inputted time interval.
.Interval: Time interval for the transmission of associated measured values defined
below.
Selection of the values which are transmitted at the set time interval.
.CyclNo:
Cycle number. Together with the cycle time (3.2.2.24), a time frame can be
generated. The other data are part of the corresponding cycle number. The
cycle number is always zeroed at the start and termination of the automatic
determination.
.SampleTemp: Associated sample temperature.
.OvenTemp: Associated oven temperature.
.GasFlow:
Associated gas flow.
Format of the transmitted values (examples):
.CyclNo
Cycle number 127
.SampleTemp Sample temperature in °C 150.0
.OvenTemp Oven temperature in °C 170.0
.GasFlow Gas flow in mL/min or L/h 100.5