Swiss+Tech Magnetic Tool Light - Manuel

Patent pending. Made in China. MMMMMMMMI ™
and MI ™ are trademarks of Swiss+Tech Products.
Specifications are subject to change without notice.
©2012 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED, batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH ® brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
www.swisstechtools.com
1-800-414-8799
ST74095
Magnetic Tool Light
Battery Replacement
1. Loosen captive screw (remains in battery
cover). Remove battery cover.
2. Remove old batteries.
3. Replace with two new CR2016 3V lithium
batteries or equivalent. Insert with positive
(+) side up. The first battery goes in under
the metal flange, the second battery goes
on top of the metal flange.
4. Replace battery cover. Tighten screw gently.
• Screwdriver Use
Insert screwdriver tip through screwdriver
slots as shown, use magnet swivel to aim.
• Metal* Use (on Iron or Steel)
Remove light from black clip, place magnet
side of light on metal* surface.
• Using Clip on Hats, etc.
Slide on, use magnet swivel to aim.
• Flashlight Use
Press button for On, press again for Off.
Metal Flange
Two CR2016
Batteries
Positive Side Up (+)
Battery
Cover
Captive
Screw
*Only ferromagnetic materials, including iron, cobalt,
nickel and steel are attracted to magnets.
Pull tab before use!