Pullman Ermator WETDRY VAC 2HP 12GL 10212P (102 12P) - Manuel

Operation & Care Instructions
Save For Future Reference
Model 102 12P
Wet/Dry Vacuum Cleaner
This vacuum cleaner is a high quality, precision made
product. All parts used in the manufacturing of this
vacuum cleaner have passed rigid quality control
standards prior to assembly and an ”each unit” fi nal
inspection prior to packaging is your assurance of
proper assembly. This vacuum cleaner was protectively
packed to prevent possible damage in transit. Should
damage occur, please notify the transporting carrier
immediately for loss and/or claim.
IMPORTANT SAFEGUARDS
MOTOR:
The suction head of this vacuum cleaner is
equipped with a 2 stage, 11.1 amp, 2HP by-pass
motor, developing 105” waterlift and 110 CFM.
When removing the motor head, care in handling
is essential. Dropping, banging or other abuse
may result in poor vacuum seal and a loss in
suction power and will invalidate your warranty.
EXTENSION CORDS:
Machines that have 3 wire cords requiring
grounding must only be used with extension
cords that have 3-prong grounding type plugs
and 3-pole receptacles.
To determine the minimum wire size required,
refer to the chart below:
Before using an extension cord, inspect it for
loose or exposed wires, damaged insulation and
defective fi tting.
NOTE: Warranty claims will be honored ONLY if
handled by an authorized Pullman-Holt Service
Center unless other prior arrangements have been
made with the Pullman-Holt Service Department.
CAUTION
Never lubricate the vacuum cleaner motor.
The motor bearings are permanently sealed.
This vacuum is intended for indoor or outdoor
use and for wet pickup, but it is not intended
to be exposed to rain.
Minimum Wire Size (AWG) of Extension Cord
Nameplate Total Extension Cord Length (Feet)
Rating-Amps 25 50 75 100 125 150 175 200
0-10.0 18 18 16 16 14 14 12 12
10.1-13.0 16 16 14 14 14 12 12 12
13.1-15.0 12 12 12 12 12 12 12 -