MARVEL Scientific MPRO6ARM - Manuel (Page 19)

Top hinge
SECTION A-A
SCALE 1 : 1
LOCK
NUT
BRASS EXTENSION
CAM
PHILLIPS SCREW
13/16 COUNTER
BORE 7/16 DEEP
15/32 HOLE
3/4 INCH
WOOD PANEL
SPRING WASHER
INNER
DOOR
FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Top hinge pin
Top door hinge
adapter
Top hinge adapter
bushing
Bottom door
hinge adapter
Bottom hinge
adapter bushing
Bottom hinge pin
Bottom hinge
cam
Figure 11
Right hand
hinges shown
Clearance hole through
door gasket channel
#10 Wood Screw
Figure 12
Back of door
Figure 10
19
Bottom
hinge
Step 8: Assemble the lock parts
Two (2) lock extensions are supplied with the lock. Use
the longer extension for a 3 ⁄
4
" thick overlay panel and the
shorter one for a 5 ⁄
8
" thick panel. Assemble the lock exten-
sion, cam stop washer, spring washer, and set screw to the
lock as shown in Figure 9 and 10.
Install this assembly into the overlay panel and secure with
the retaining nut using a 15mm socket. Make sure the key
slot in the lock is vertical.
Step 9: Secure overlay panel to the door.
With the #10 wood screws provided, fasten the overlay
panel to the door. (See Figure 12).
Step 10: Install lock cam (Models with locks
only).
Attach the lock cam to the back of the lock assembly with
the phillips head machine screw provided. Orient the lock
cam vertically when installing on the lock.
Step 11: Install door gasket
Press the door gasket into the door channel. Make certain
the gasket corners are fully inserted. If applicable insert
the key into the lock and make certain the lock operates
properly.
Step 12: Install the door
Install the top and bottom hinge adapter bushings back into
the hinge adapters that were removed in step 6. Install the
door by reversing the procedure from step 2. Install the top
hinge pin so the screw head is flush with the top surface of
the hinge. If applicable insert key into lock and verify the
lock cam works properly with the catch bracket on the front
of the refrigerator cabinet.