CompuSTAR 2WFM (LCD) (Remote 2WFMR) Manuel d'utilisation
Page 4
Page 6
Remote-Pager Learn Routine
Page 7
Step2 :
Within a 7 second period after cycling the ignition for the 5t h time,
press button I. The parking lights will flash once to confirm that the
transmitter has been programmed. You can continue programming
additional remotes. The parking lights will flash two times when the
programming mode has expired.
Displays remaining battery life.
Displays running time left - each bar represents 25% of the running time.
Indicates that your door is open.
Indicates that your vehicle has auto-started properly or that the ignition is on.
Indicates that your trunk is open.
Note : "
"
Represents pressing the button for 2 seconds.
"
( )
"
Repr esents simultaneously pressing the buttons.
"
(
)
"
Represents simultaneously pressing the buttons for 2 seconds.
1
2
3
4
5
6
7
8
9
10
11
12
I
I I
I I I
I V
I-
II-
III-
IV-
( I + I I )
( I + I I I )
( I I + I I I )
( I I + I V )
( I I I + I V )
1/2 sec
1/2 sec
1/2 sec
1/2 sec
2 sec
2 sec
2 sec
2 sec
1/2 sec
1/2 sec
1/2 sec
1/2 sec
1/2 sec
Lock / Arm
Unlock / Disarm
AUX 1
AUX 2
Query Function
Auto Mode - on/off
Auto-start Function - on/off
Trunk Release
Panic, Press button
I
to shut off siren.
Siren Chirp – on/off
Valet Mode – on/off
Passive Arming – on/off
Timer Start Mode – on/off
Turbo Mode - on/off (2WFMR)
2
nd
Car - on/off (2WFMR-2
nd
)
Button
PressedFor
Function
Remote-Pager Button Functions
13
( I + I I I ) -
( I + I I ) -
( I + I V ) -
2 sec
2 sec
2 sec
Shock Sensor – on/off
Programming Menu 1
Programming Menu 2
14
15
16
Note :
If you lose your remote after you have armed the vehicle, use your key
to open the door. The siren will go off. Turn the ignition on then off,
5 times with your key to shut down the alarm and put the system into
valet mode. You can cancel the valet mode with a remote later on.
See: Valet mode, on page 10.
Note :
(Siren duration is 30 to 60 sec depending on the options set at the time
of initial installation.)
Press button
II
for 2 seconds to auto-start an automatic transmission engine.
Remember, that a manual key in the ignition is required to drive the car.
For manual transmission vehicles, please use reservation mode.
Press button
I I
for 2 seconds in order to turn off an auto-started car.
The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset
options at the time of installation, and then shut off.
Auto-Start Function
The Compustar system will allow up to three remotes to be programmed to one
vehicle. Please perform the following procedure to add or reprogram additional
remotes.
Step1 :
Activate Valet/Programming mode by manually turning the ignition
on and off five times (between Acc and On)
with the key within a 7 second period.
The parking lights will flash once with successful
completion of this step.