Napier 13100 Backroadz SUV Tent Manuel d'utilisation

Page 2

Advertising
background image

CAUTION

• Never smoke inside the tent. Never use candles, light

matches or allow any type of open flame in or near the

tent.

• Do not cook inside the tent.

• Do not store flammable liquids inside the tent.

• Allow adequate ventilation inside the tent at all times.

Never refuel lanterns, heaters or stoves inside the tent.

Leaving the tailgate open for an extended amount of

time will drain the battery of your vehicle. To avoid this,

ensure your interior lights are turned off

NEVER run the engine when the tent is attached to the

vehicle.


- Select a smooth level campsite clear of rock, branches

and other hard or sharp objects.
- Park the vehicle into the chosen campsite with the vehicle

in park and turned off. Apply the parking brake.

SETTING UP THE TENT

SELECT CAMPSITE

1) Remove the tent from the tent bag and lay it flat on the

ground with the vehicle sleeve facing the cargo area of

the vehicle. At this point, do not stake the tent to the

ground.

2) Assemble all poles by unfolding each section. You will

have 2 long tent poles and one short rainfly pole.

3) Slide one tent pole diagonally, corner to corner going

through the 2 pole sleeves in the roof of the tent. Repeat

with the other tent pole.

4) Take any pole end and insert the pin located on the

corner of the tent into the pole end. On the opposite

end of the pole, insert the pin into the end of the pole.

Repeat these steps for the remaining pole.

NOTE:

The poles may get stuck on the pole sleeves. Do

not force the pole, simply go to the sleeve and lead the

pole through it.

5) Once the tent is standing, attach the plastic clips to

the tent pole.

© 2012 Napier Outdoors – All Rights Reserved.

Rev. 01 09.7.2012

2 of 8

Advertising