Napier 57 Series Truck Tent - Manuel (Page 3)

Rev. 05 8.23.13
2014 Napier Enterprises
3 of 7
13)
14)
12)
B
B B
B
D
D
C
C
A A
SETTING UP THE AWNING
SETTING UP THE RAIN FLY 7) Insert the poles into the pole pockets in the below order.
8) Once the tent is assembled, attach the pole clips to
the tent pole.
9) If the tent side straps are too loose, tighten the straps.
Remember the straps should not be too tight.
10) To install the gear loft, place each corner hook of the
gear loft into the loop located on the ceiling of the tent.
Locate the front of the rain fly that goes over the door (it
will have a Napier tag on one side). Place the rain fly
over the tent (zipper side to rear).
Attach the rain fly to the tent by clipping the 6 straps (2 per
side and 2 at tailgate). Tighten the straps if necessary.
Slide the navy blue inside awning poles (2) through
the pole sleeve in the roof of the awning. Insert the poles
into the pole pockets on each corner of the awning.
NOTE: If you do not wish to use the awning, roll up the awning
and secure it with the toggles.
A) Insert the light gray (side-to-side) pole into the black
webbing pocket above the window.
B) Insert the blue (corner-to-corner) pole into the blue pole
pocket near the truck’s cab. Insert the other end into
the blue pole pocket by the tailgate. Repeat with the other
blue pole.
C) Insert the end of the short green (rear cab) pole into
the grommet hole located on the tab near the side
of the tent. Repeat on the other side.
D) Insert the long green (tailgate) pole into the green pole
pockets at the tailgate.
E) Insert the black (inside) pole into the black pole pocket
(above door and rear cab access) inside the tent. Velcro
the pole to the tent using the Velcro tabs and tie in the
center.
11)
16)
Place the pointed end of the bottom awning pole into the
grommet hole at the tailgate. Place the other end into the
grommet hole at the corner of the awning. Secure with
strap. Repeat for the other pole.
SETTING UP THE GEAR LOFT
15)
Assemble the awning poles (6) by unfolding each section.
Insert the top awning pole into the bottom pole which has
the plastic clasp (clasp must be open). Close the clasp
once you have the desired height of the pole.
To secure the awning to the ground, insert 1-2 guide ropes
with ring around the top awning pole point and place the
awning cap over the point. Stake the other end to the
ground with a peg. Adjust the guide rope length.