Napier 57 Series Truck Tent (Orange Poles) - Manuel (Page 3)

2012 Napier Enterprises
Rev. 01 01.06.12
3 of 7
12)
13)
11)
B
B B
B
D
D
C
C
A A
SETTING UP THE AWNING
SETTING UP THE RAIN FLY
The poles may get stuck on the pole sleeves. Do
not force the pole, simply lead the pole through the sleeve.
NOTE:
7) Insert the poles into the pole pockets in the below order.
8) Once the tent is assembled, attach the pole clips to
the tent pole.
9) If the tent side straps are too loose, tighten the straps.
Remember the straps should not be too tight.
10) To install the gear loft, place each corner hook of the
Gear loft into the loop located on the ceiling of the tent.
Locate the front of the rain fly that goes over the do or.
It will have a woven Napier logo tag. Place the rain fly
over the tent. You may need assistance due to height.
Attach the rain fly to the tent by clipping the 6 straps (2 per
side and 2 at tailgate). Tighten the straps if necessary.
Slide the gray poles through the pole sleeve in the roof of
the awning. Insert the poles into the pole pockets on each
corner of the awning.
NOTE: If you do not want to use the awning, roll up the
awning and secure it with the toggles.
A) Insert the light gray (side-to-side) pole into the black
webbing pocket above the window.
B) Insert the blue (corner-to-conrer) pole into the blue pole
pocket near the truck’s cab. Insert the other end into
the blue pole pocket by the tailgate. Repeat with the other
blue pole.
C) Insert the end of the short orange (rear cab) pole into the
grommet hole located on the orange tab near the side of
the tent. Repeat on the other side.
D) Insert the long orange (tailgate) pole into the orange pole
pockets at the tailgate.
E) Insert the black (inside) pole into the black pole pocket
(above door and rear cab access) inside the tent. Velcro
the pole to the tent using the Velcro tabs.
10)
14) Insert the ring on the guide rope around the point and place
the awning cap over the guide rope. Stake the other end of
the ground with a peg. Adjust length of guide rope.
Assemble the awning poles (4 pieces). Insert the top pole
into the bottom end with clasp. Place one pointed end into
the grommet hole at the tailgate. Place the other end into
the grommet hole at the corner of the awning. Secure
with scrap. Repeat for the other pole.