Philips BODYGROOM Series 5000 Tondeuse corps - Manuel (Page 3)

When you use the appliance in the shower or
bath, apply some shaving foam or shower gel
to your skin.
Cleaning and maintenance
Clean the appliance after every use.
Never use compressed air, scouring pads, abrasive
cleaning agents or aggressive liquids such as
petrol or acetone to clean the appliance.
Note: The trimming and shaving attachments do not
need any lubrication.
1 Switch off the appliance.
2 Remove any comb and/or attachment from
the appliance.
3 Blow and/or shake out any hair that has
accumulated in the trimming attachment
and/or trimming combs.
4 Clean the trimming and shaving attachments,
the trimming combs and the handle with
lukewarm water and/or with the cleaning
brush.
To clean the trimming and shaving attachments,
see the sections ‘Trimming attachment’ and ‘Shaving
attachment’ below.
5 Clean the adapter with the cleaning brush or
a dry cloth.
Make sure the adapter does not get wet.
Trimming attachment
1 Put your thumb under the tab to remove the
cover off the trimming attachment (Fig. 13).
2 Rinse the trimming attachment with
lukewarm water.
3 Remove hairs from the inside of the trimming
attachment with the cleaning brush and/or
with lukewarm water (Fig. 14).
4 After cleaning, snap the cover back into
the trimming attachment (‘click’) (Fig. 15).
Shaving attachment
1 Pull the shaving foil unit out of the shaving
attachment (Fig. 16).
Note: The shaving foil unit is very delicate. Handle it
carefully. Replace the shaving foil unit if it is damaged.
2 Rinse the shaving foil unit with lukewarm
water. Make sure that you also remove any
hairs that have collected under the trimmers.
Do not clean the shaving foil unit with the
cleaning brush, as this may cause damage.
3 Remove hairs from the inside of the shaving
attachment with the cleaning brush and/or
with lukewarm water (Fig. 17).
4 After cleaning, snap the shaving foil unit back
into the shaving attachment (‘click’) (Fig. 18).
Storage
The charger has a special storage unit in which you
can store the trimming or shaving attachment, the
cleaning brush and the two combs.
1 Place the cleaning brush in the brush
holder (Fig. 19).
2 Place the trimming or shaving attachment on
top of the attachment holder (Fig. 20).
3 Slide the two trimming combs sideways
into the guiding grooves of the attachment
holder. The tips of the combs must point
forwards (Fig. 21).
- 4 Slide the storage unit onto the back of the
charger (Fig. 22).
5 To remove the storage unit, pull it off the
back of the charger (Fig. 23).
Replacement
If you use the shaving attachment very frequently,
replace the shaving foil unit (type number TT2000)
every year. Replace a damaged shaving foil unit
immediately.
1 Pull the shaving foil unit out of the shaving
attachment (Fig. 16).
2 Snap the new shaving foil unit into the shaving
attachment (‘click’) (Fig. 18).
Environment
Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment (Fig. 24).
The built-in rechargeable battery contains
substances that may pollute the environment.
Always remove the battery before you
discard and hand in the appliance at an official
collection point. Dispose of the battery at an
official collection point for batteries. If you have
trouble removing the battery, you can also take
the appliance to a Philips service centre. The
staff of this centre will remove the battery for
you and will dispose of it in an environmentally
safe way.
Removing the rechargeable battery
Only remove the rechargeable battery if it is
completely empty.
1 Take the appliance out of the charger and let
the motor run until the rechargeable battery
is completely empty.
2 Remove any comb and/or attachment from
the handle.
3 Remove the back panel with a
screwdriver (Fig. 25).
4 Remove both side panels from the handle
with a screwdriver (Fig. 26).
5 Remove the clamps on the left and right side
of the handle with a screwdriver (Fig. 27).
6 Separate the two handle parts (Fig. 28).
7 Cut the two wires to separate the batteries
from the printed circuit board (Fig. 29).
8 Remove the batteries with a
screwdriver (Fig. 30).
Do not connect the appliance to the mains again
after you have removed the rechargeable battery.
Guarantee & service
If you need information or if you have a problem,
please visit the Philips website at www.philips.
com or contact the Philips Customer Care Centre
in your country (you find its phone number in
the worldwide guarantee leaflet). If there is no
Customer Care Centre in your country, go to
your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and
Personal Care BV.
Guarantee restrictions
The shaving attachment, the trimming attachment
and the rechargeable batteries are not covered by
the terms of the international guarantee because
they are subject to wear.
-
-
4203.000.5994.1 3/9