Connect drain hose – Whirlpool WTW5500BW Manuel d'utilisation

Page 5

Advertising
background image

5

Remove tape from washer lid, open lid and remove cardboard

packing tray from tub. Be sure to remove all parts from tray.
NOTE: Keep tray in case you need to move washer later.

Firmly grasp power cord plug and pull to free from rear panel.

Gently place power cord over console to allow free access

to back of washer.

CONNECT DRAIN HOSE

Place hose into standpipe (shown in picture) or over side

of laundry tub.

IMPORTANT: 4.5" (114 mm) of drain hose should be inside

standpipe; do not force excess hose into standpipe or lay

on bottom of laundry tub. Drain hose form must be used.

3.

Remove packing tray from tub

4.

Free power cord

6.

Place drain hose in standpipe

4.5"

(114 mm)

Drain

hose form

Remove the red plastic plug from the black drain port on the

back of the washer.

If clamp is not already in place on elbow end of drain hose,

slide it over end as shown. Squeeze clamp with pliers and

slide black elbow end of drain hose onto black drain port

and secure with clamp.

For a laundry tub or standpipe drain, go to step 6.

For a floor drain, remove the preinstalled drain hose form as

shown in Step 7. You may need additional parts with separate

directions. See “Tools and Parts.”

5.

Attach drain hose to drain port

Advertising
Ce manuel est liée aux produits suivants: