Whirlpool UXT4230ADS - Manuel (Page 11)

11
Replacing the Incandescent Light Bulb
Turn off the range hood and allow the light bulb to cool.
1. Disconnect power.
2. Squeeze the plastic lens cover and remove it from the hood.
3. Screw a 120V, 75W maximum, incandescent light bulb with
E26 base into the socket.
4. Replace the lens cover by squeezing the cover and inserting
the tabs into the slots.
5. Reconnect power.
If the new light does not operate, make sure the light bulb is
inserted correctly before calling service.
WIRING DIAGRAM
L 3
2 1
C25
SE114A
1.2 ±10% A
73 ±10% Watts
17.1 ±10% Ohms
13.6 ±10% Ohms
Motor Characteristics
Power Supply 120 VAC
Frequency 60 Hz
Amperage
Wattage Rating
Motor Resistance
White - Red
White - Black
Lamp Switch
Off - Low - High Motor Switch
Off - On
Lamp Switch
Operation
1 - 3 Low
1 - 2 Off
1 - L High
Ground
Screw
GND L N
BK
W R
Speed 2 Common Speed 1
R W
NOTE: Speed 1
not used
R BK
BK
R
BK W
BK W
Y
Rectifier
Diode