Whirlpool W10197087 - Manuel (Page 2)

2
Install the freezer handle
IMPORTANT: See Figure 2 and the Freezer Door table for handle
mounting hole requirements as well as handle mounting hole
locations.
1. Measure from the side of the custom panel and mark your
first hole location as shown in Figure 2 and the Freezer Door
table.
Figure 2: Freezer door
NOTE: Measurements from the top edge of the door will
depend on specific application.
2. Drill a ³⁄₁₆" (4.76 mm) hole at that location, then measure from
that hole over to the second hole. Countersink both holes on
the inside of the panel,
¹⁄₄" (6.35 mm) deep and ⁵⁄₈" (1.58 cm)
diameter for screw head clearance.
3. Install two mounting studs to the custom panel using the
screws provided. Check that the head of the screw is flush
with the panel.
4. Install handle to handle mounting studs and tighten the
setscrews. Some adjustments of the handle mounting studs
may be required to allow the handle to fit over both mounting
studs.
NOTE: The freezer handle setscrews should face down.
Freezer Door
Dimension Bottom Mount
Freezer
French Door Bottom
Mount Freezer
Euro handle Pro handle Euro handle Pro handle
A 5" 5
⁵⁄₈"
8
⁹⁄₁₆"
5
³⁄₈"
B 24 ³⁄₄" 23 ⁹⁄₁₆" 23 ⁹⁄₁₆" 30"
Handle
Mounting Studs
Freezer
Compartment
Handle
Custom Freezer
Compartment Panel
#10-24 x 1" Screws
B
A
Setscrews