Whirlpool WRT311FZBM Manuel d'utilisation

Page 7

Advertising
background image

7

Reverse Doors and Hinges

IMPORTANT:

Your model may have either handles that extend from the door
or cup handles which are recessed into the doors. If your
model has cup handles, disregard instructions pertaining to
moving the handles to the opposite side.

See complete graphics later in these instructions.

Reverse Center Hinge

1. Remove the three screws (that match the exterior finish) from

the handle side and use them to fill the holes created when the
hinge screws were removed.

2. Using the three

⁵⁄₁₆" hex head hinge screws, removed in

Step 9, insert two screws halfway into the holes, leaving
space to insert the Center Hinge.

3. Slide the center hinge, from the right, onto the screws, insert

the third screw, and tighten all screws completely.
NOTE: Make sure the washers are in place on both the top
and bottom pins of the center hinge.

Reverse Freezer Door

1. Remove the three cabinet hole plugs from the top of the

cabinet and place them in the hinge holes on the opposite
side.

2. Remove the two screws from the bottom of the freezer door

handle.

3. Using the

¹⁄₈" hex key, loosen the setscrew attaching the top of

the handle.

4. Pull the lower part of the handle away from the door and push

upward on the handle to release it from the shoulder screw.
Keep all parts together.

5. Using the plastic tool (provided), remove the brand badge

from the freezer door by prying up the right-hand side and
slowly peeling the badge away from the door, revealing the
hole to mount the door handle.
NOTES:

To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.

Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.

6. Remove the shoulder screw from the left-hand side of the

door and fasten it into the hole that was behind the brand
badge.

7. Place the handle on the shoulder screw and push the handle

toward the door until the mounting base is flush against the
door. Tighten the setscrew.

A. Screws matching exterior finish

A.

⁵⁄₁₆

" Hex head hinge screws

B. Washers

Door Handle

Screw Hole Plug

Round-Head

Handle Screw

A

A

A

B

A

A. Freezer handle
B.

¹⁄₄

" Setscrew

C. Flat-head handle screws

A. Setscrew

C

A

B

A

Advertising