Pioneer PDK-1015 - Manuel (Page 7)

7
En
English
Detaching the Plasma Display from the Stand
To remove the Plasma Display from the stand, be sure
to always follow the procedure described below to
prevent accidents.
1
First clear a space on a flat floor etc. where
you can lay the Plasma Display flat, then
lay a sheet to protect it from scratches or
other damage.
2
Remove the speakers.
3
Referring to step 2 in “Attaching the
Plasma Display” (Page 4.), remove the
installation bolts (4 screws).
4
Holding the Plasma Display by its handles
at the bottom, with your other hand hold
the top, lift the display vertically.
5
Place the Plasma Display slowly onto the
sheet laid out in step 1 with its screen
facing downwards.
Caution
Preparing the cables
Use the enclosed cable clamps to bind the cables.
Note
Be very careful not to apply force to the bases of the cables.
2
Bundle the cables and place them on each
cable clamp.
Loosening a cable clamp
If a cable clamp is closed
too tight, press the
button shown on the left
and push the extremity
of the cable clamp to
loosen it.
Button
3
Close each cable clamp, and then pull its
extremity to make the cables immobile.
Opening a cable clamp
Unlock here
with a finger.
Cable clamps
Cable clamp
mounting holes
1
Insert the cable clamps into the cable
clamp mounting holes.