American Comfort PAC - Manuel (Page 11)

When the water tank is full, the unit will switch off automatically and beep
15 times, the
TANK FULL LED
on the control panel will light up. The tank needs
to be emptied:
• Make sure unit is unplugged from power source
• Remove the water tank by pulling the clasp under the bottom.
• Empty the water tank.
• Push the water tank gently back in place. Plug the unit back into power
source. When done properly, the
WATER FULL LED
will turn off.
1. Do NOT remove the fl oat sensor device from the water tank. If removed,
the water full sensor will no longer be able to detect the water level
correctly without the fl oat and water may leak from the water tank.
2. If the water tank is dirty, wash it with cold or lukewarm water. Do not use
detergent, scouring pads, chemically treated dust cloths, as these can scratch
and damage the tank and cause water leakage.
3. When inserting the drainage tank, press the tank fi rmly into place with both
hands. If the tank is not positioned properly, the sensor will still be activate,
and dehumidifi cation can not operate.
Pull
Water
Tank
Float Sensor
Device
Emptying The Water Tank
9