NaceCare Solutions TTB1120 - Manuel (Page 11)

11
The TTB / ETB Range are all equipped with a 11 gal clean-water tank allowing large areas to be cleaning in a single
fill.
Filling the clean-water tank
To fill the clean-water tank, use the FLEXI-FILL
pipe from either a tap or hose pipe (Fig.21).
The large cap can also be unscrewed for filling
from a bucket or suitable
container.
Fill the clean-water tank to a maximum of 11 gal,
including cleaning chemicals if required.
Follow chemical manufacturing guide lines.
Note.
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process.
If using a bucket or similar, ensure it is always clean and free from debris.
Machine Set-Up
The clear dump hose at the rear of the machine can be used to see the level of the clean water.
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Fig.21
WHEN HANDlING AND MIxING CHEMICAlS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-dryers.
! !
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
! !
Pre-cleaning advice.
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig.22).
Numatic part (629044) Wet Floor sign
(available if required)
Fig.22