Napoleon Fireplaces Castlemore GDS26 - Manuel (Page 35)

35
W415-0827 / D / 08.10.12
C. Place the center log as shown, follow con-
tour of burner and ensure port holes are not
covered. D. Place the hole in the underside of the right log
onto the locating pin, on the burner base and
rests against the rear log as shown.
E. Re-install the glass door.
6.4 CHARCOAL EMBERS
32.1
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
6.5 VERMICULITE
33.1
Sprinkle vermiculite around the charcoal embers.
NOTE: Vermiculite is not to be placed on the burner.
Remove the backing from the logo and position onto the
control door as shown.
LOGO 1.27cm
1.27cm
Tear the embers into pieces and place along the burner ports covering all of the burner. Care should be taken
to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow. The
ember material will only glow when exposed to direct fl ame; however, care should be taken to not block the
burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Phazer
TM
logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and Phazer TM logs available from
your Napoleon® dealer.
6.6 GLOWING EMBERS
6.7 LOGO PLACEMENT