Napoleon Fireplaces S9 - Large Stove - Manuel (Page 18)

W415-1226 / 06.27.13
18
EN
5.0 FINISHING
A. Remove the bottom door hinge retainer by removing the screw, as shown below, then loosen the top
door hinge retainer.
B. Lift the door up and off of the hinge rod.
C. Carefully place the door facedown, on a soft surface, to avoid scratching the paint.
D. To install the door reverse these steps.
5.1 DOOR REMOVAL / INSTALLATION
HINGE ROD
DOOR HINGE RETAINER
DOOR HINGE RETAINER
HINGE SCREWS
LATCH BLOCK
HOUSING
Ensure to have a fi rm grip of the door at all times.
NOTE: We recommend having two people perform this installation.
5.1a DOOR ADJUSTMENT
A. Loosen the two hinge screws to adjust the horizontal (levelling) position of the door.
B. Tighten the two hinge screws after the desired door position has been reached.
5.1b LATCH BLOCK HOUSING ADJUSTMENT
A. Loosen the two screws of the latch block housing.
B. Shift the latch block housing up or down to suit the desired
handle pitch. (HINT: Shifting the latch block housing up
will result in a lower handle pitch. Shifting the latch block
housing down will result in a higher handle pitch.)
PITCH OF HANDLE IN
CLOSED POSITION